Q52 - Checking clicker
Last Updated 16/04/2014 at 11:25:13 AM EST
Dear Coach Lee:
 
When I check my clicker during the transfer-to-holding phase I notice that my draw gets to a still-stand or even a slight let-go (2-4mm), especially when drawing decisively as recommended in the B.E.S.T.
method. Is this OK or does it indicate some flaw in my technique? Do I need to slow down at the end of my draw at the end to avoid this let-go?
 
Thank you for your advice.
January 25, 2008
from M.M. of Switzerland:

"Dear Coach Lee:
 
When I check my clicker during the transfer-to-holding phase I notice that my draw gets to a still-stand or even a slight let-go (2-4mm), especially when drawing decisively as recommended in the B.E.S.T. method. Is this OK or does it indicate some flaw in my technique? Do I need to slow down at the end of my draw at the end to avoid this let-go?
 
Thank you for your advice. "
It is very difficult for me to answer this question without seeing you doing it, as there cpuld ne various reasons. However, let me explain the process as follows: There is a rhythm of Loading, Anchor and Transfer, 1_2_____3. One being Loading, where the drawing scapula is set down and “locked” into position, whilst the drawing hand comes to anchor(2) on the face - the draw scapula must NOT move. You can see on the KSL Shot Cycle Diagram (on this website) that there is an overlap between the Drawing and Loading/Transfer(3) phases and that is where we change direction from a linear to and angular movement, so there is no STOP, just a change of direction. This overlap is designed to enable the smooth and continuous movement from linear to an angular movement.
 
You can liken it to a golf swing, the golf club is going to pause or looks like stopping on the top of the swing when changing direction from back swing to down swing. So that the clicker could stop or pause a short time or even could go forward a little bit.
 
This is good question, because the point of the arrow of some people's will actual stop and sometimes will even go forward a little bit, even though the archer is doing the right core steps. I would need to visually watch you shooting to establish accurately what is happening, but 4mm will be too much and might point to a loss of back tension when anchoring and going from a linear to angular movement.

Log In
Site designed and maintained by Jon Barnard © Copyright 2014. Ki Sik Lee Online. All Rights Reserved.